Description
The text refers to standards and codes, using designations such as ANSI ,B31.1,ASTM,A-53,ISA S5.1-1968,e.t.c.Full titles of these standards and codes will be found in tables 7.3 through 7.15.
References :- Numbers in straight brackets(thus : {12}) refer to sources of published information listed under 'References' , at the end of the index.
Sections, figures, charts and tables in Part 1 are referred to numerically, and are located by the margin index.Charts and tables in Part II are identified by letter.
The authors are grateful to the companies, designers, and engineers who assisted in the development of the Piping Guide.Apart from source material,individual acknowledgements are not made because neither these contributors nor the authors assume liability or responsibility for designs using information presented herein.The user is responsible for complying with the various codes and standards,Federal,State, and Municipal regulations, and other legal obligations which may pertain to the construction of plants, industrial installations,e.t.c.Discussion or mention of products does not necessarily imply endorsement.
Table of Content :-
- PIPING : USES, EXPENDITURES, & PLANT CONSTRUCTION
- PIPE,FITTINGS,FLANGES,&LINE EQUIPMENT
- VALVES,PUMPS,COMPRESSORS, & PROCESS EQUIPMENT
- ORGANIZATIONS :JOB RESPONSIBILITIES,DRAWING OFFICE EQUIPMENT,&PROCEDURES
- DRAFTING :PROCESS &PIPING DRAWINGS
- DESIGN : ARRANGEMENT,SUPPORT,INSULATION,HEATING,VENTING,DRAINING OF PIPING SYSTEMS,VESSELS&EQUIPMENT.
- STANDARDS & CODES : PIPING SYSTEMS, DRAFTING SYMBOLS, PIPE, PIPE SUPPORTS, FLANGES ,GASKETS, FITTINGS ,PUMPS, VALVES ,STEAM TRAPS, VESSELS ,ECHANGERS, & SCREW THREADS
- ABBREVIATIONS FOR PIPING DRAWINGS & INDUSTRIAL CHEMICALS
-page-001.jpg)
0 Comments